Step #3 : assemlbly of the front ultrasonic sensor

arduino4fun
Site Admin
Posts: 37
Joined: Mon Jun 06, 2016 1:16 pm

Step #3 : assemlbly of the front ultrasonic sensor

Postby arduino4fun » Wed Jun 08, 2016 3:23 pm

Assemlbly of the front ultrasonic sensor, I have not used the original screws because they were to short the nuts correctly, I have used longer screws and put the nuts inside glued (pic #1,#2) this is not problem for the move of the servo; the last piece supplyed is not use in our case and there are some screws not used, I have used the inline guide of the servo instead of the cross, nota : in all the cases, you need to enlarge the holes to fit the screws (do this manually, see pic #1); next step : servo test with a sketch.

Image
Image
Image
Image
Image
Image
Image
Image

Return to “Multifunction Bluetooth Controlled Robot Smart Car Kits For Arduino”

Who is online

Users browsing this forum: No registered users and 0 guests